Eyefinty good for a year, today it wont work.
Posted: 01 Jan 2011, 10:38
I am a bit stuck! I have had eyefinity going since october 2009 on my 5970 and apart from the early struggles its been working fine.
For over a year I have had it going at 5760x1200, at times I have disabled the group and recreated with no issues at all. Today I was playing DCS A10 and I control escaped from full screen in to the desktop and I was greeted by an eyefinity display in duplicate mode across 3 monitors. I have ctrl-esc out of this game lots of times and this never happened.
So now my problem is that I cannot create the 3x1 display group again. I do it the same way I have always done it but it just wont work. It goes through the steps and even asks me if my monitors are in the right position but even at that point I am in duplicate mode. If I go to screen resolution I have the group res options but if I click on them and apply nothing happens.
I uninstalled the drivers and them used driver sweeper in case something lingering had been corrupted. Reinstalled and the same problem..
Does anyone know!?
Thanks all.
For over a year I have had it going at 5760x1200, at times I have disabled the group and recreated with no issues at all. Today I was playing DCS A10 and I control escaped from full screen in to the desktop and I was greeted by an eyefinity display in duplicate mode across 3 monitors. I have ctrl-esc out of this game lots of times and this never happened.
So now my problem is that I cannot create the 3x1 display group again. I do it the same way I have always done it but it just wont work. It goes through the steps and even asks me if my monitors are in the right position but even at that point I am in duplicate mode. If I go to screen resolution I have the group res options but if I click on them and apply nothing happens.
I uninstalled the drivers and them used driver sweeper in case something lingering had been corrupted. Reinstalled and the same problem..
Does anyone know!?
Thanks all.