16x9 support

[stu517]

i have 3 Dell 2409W monitors hooked to a th2go digital and 9600GT video card. i have latest firmware and software but highest resolution available is the 3x1368x76x. it is fine but i was hoping to try the 1440x900 resolution. No matter what i do i cannot get that resolution to appear as an option - btw the compatibility tool says no problem for the higher modes. any thoughts on what i should try next?

thanks

stuart

[[email protected]]

Did you use the mode expander tool?

[scavvenjahh]

MEP is for the Analog version only afaik :?:

stu517, did you try setting 4320x900 as a custom res in nvidia control panel ?

[stu517]

nope.but i will give it a try. thanks so much 8)

[stu517]

So i have tried 3 different nvidia drivers and the latest GXm software. The monitors go blank on anything higher than 1366x768. I guess i am spoiled having lived the good life with 1920x1200 in the past. Any ideas to try otherwise these monitors are going up on ebay and i will do a 22" (16:10) solution.

Thanks for ideas.

[[email protected]]

Try plugging in on monitor directly into the PC and then set it at the proper resolution and frequency (57Hz)

[stu517]

when done directly the monitor supports 1440x900 and 1680x1050 @ 57 hz. Matter of fact the monitor will actually run @ 30 hz 1680x1050.

That said I cannot get the TH2Go to work at the higher resolutions.