Re. TripleHead2Go Problem

[toktiny]

Hi there,

I have been useing the TripleHead2Go for some time now and wonder how I ever managed without it. I use the 3840 x 1024 settings for three 20" flat screen monitors and they work fine. However, I have two small problems which I find a little irratating at times and wonder if anyone can help me put them to bed. They are as follows;

1. Occasionally my FPS will drop from the usual 25 - 30 down to 4 - 6 and remain at this . How I can bring it back to 25 - 30 is to press "RESTORE DOWN" (which reduces the screen number to one) and then press "MAXIMISE" which will bring back the three screens and also restore the FPS to 25 - 30. Why is this happening ?

2. Again on occasions all three of my screens will get a pink hue for a short time (avg. 5 seconds) and then will restore to normal vision.

As I have said above nether of these two problems are constant and they happen as seperate items at random. The drop in FPS which does not correct itself but remains "Locked" until I carry out the remedy outlined. I should also mention that I use "Smart Close " to close down all unneccessary programs while FSX is running.

Many thanks for any help which might help.

TokTiny

[scavvenjahh]

Help us help you with a help that might help :P
What's your config like ? (graphics card, OS, RAM, any o/c...?)

[toktiny]

Hi there,

Many thanks for your reply . Below find some details of my setup:

> Mainboard : Asus P5N32-SLI-SE-Deluxe
> Chipset : nVidia nForce4 SLI X16 Intel Edition
> Processor : Intel Core 2 Duo E6700 @ 2666 MHz
> Physical Memory : 2048 MB (2 x 1024 DDR2-SDRAM )
> Video Card : Nvidia Corp GeForce 7950 GX2
> Hard Disk : Maxtor (82 GB)
> Hard Disk : WDC (250 GB)
> DVD-Rom Drive : SONY DVD RW AW-G170A
> Monitor Type : One F159B - 15 inch FB
> Monitor Type : Three 20 inch FB
> Network Card : Marvell Semiconductor (Was: Galileo Technology Ltd) Yukon 88E8053 PCI-E Gigabit Ethernet Controller (Copper)
> Operating System : XP Professional 5.01.2600 Service Pack 2
> DirectX : Version 9.0c (March 2006)

Hope this may help.

TokTiny

[[email protected]]

The pink hue sounds like a problem with your cables, a way to test this would be to jiggle the cables and see if this happens.

[toktiny]

Hi there,

Many thanks for your reply.
I am afraid that I have tried this with the cables several times without success and also have removed the Matrox software and reloaded a number of times without fixing the problem.

Regards

TokTiny

[toktiny]

Hi there,

I posted my setup details as requested. Has anyone got any idea of how to overcome problem ?

Thanks in advance.

TokTiny

[Tyinsar]

I had a 7950 GX2. I traded it to a friend. He had issues a week later and sent it in for warranty. He got a 9800 GX2 back. D'oh!

I wonder if you card is going bad on you.