Widescreen Gaming Forum

Hey everyone, I'm new here. Recently I've bought 3 Dell U2311H for Eyefinity setup. I've connected one displayport cable ( http://www.dealextreme.com/details.dx/sku.37595 ) and 2 dvi cable to my 5870. I'm currently using CCC 10.9 and window 7 64bit. Once I've boot up my computer, there will be a beeping sound and all of the monitor will enter power saving mode while my 5870 will be running at 100% fan speed. Therefore I would have to disconnect 2 of my monitor and the desktop will power on as per normal.

Here where the problem lies, every time after I've manually shut down the computer and on it again. The beeping sound will appear and I would have to go through all the disconnection part again whereas when I restart the computer, no beeping sound can be heard and I'll be able to start up the computer perfectly fine. Anybody care to share what may be the cause of this problem? Pardon me for my english and thanks alot :?

Your english is fine, just hope you understand our replies.

What power supply does your computer have? If it isn't a branded one, what does the 3.3v, 5v and 12v current rating say? It will be in XX A, ampares.

Also, how many beeps happen? Is it 3 beeps then stops? Endless beeping?

The beep is a BIOS fault code, so detailing your motherboard model would be helpful too.

_________________
P8Z68-V Pro | 2600K | HR02 | HD5850 | 2x4GB Vengeance LP | 128GB M4 + 6TB | X-Fi > HD595 | AX850 | Tai Chi | PB278Q | G110 + Deathadder 2013
P8Z77-V | 3570K | Mugen 2 | HD5850 | 2x4GB Vengeance LP | 500GB | X-750 | Fractal R3 | U2212HM | G110 + G400
P8H77-I | G860 | 4650 | 2x2GB XMS | 320GB | CX500 | Prodigy | T22B350EW | MX518
DC3217IYE | 1x4GB Vengeance | 64GB M4 | TX-42VT20E

I'm currently using Andyson F600M, similar to Seasonic. Hmm...there only 3 beeping sounds and the motherboard I'm currently using is Asus P55D-PRO.