Widescreen Gaming Forum

Hay to all,

Please if you can help me with settings eyfiniti. I have one 55 "Samsung LED TVs and one 23" acer monitor (monitor in the center below the TV)) which both have a resolution of 1920x1080. The problem is that when I configure eyfiniti part of the picture on the 23 "acer is too small. If I set the resolution on the 23" monitor at 854 X480 everything is fine when it is set in W7 on the extended desktop. In eyfiniti, this resolution of the 23 "Monitor 854 x 480 returns to 1920 x1080 and part of the image is again too small in comparison with the TV.

Thanks.

Hi,

it's somewhat hard to understand what you're talking about.
You think you could make some Screenshots and pictures ?

Hay,

this is my setup.

Ahhh i get it.

You might have a chance with an EDID edit of the smaller monitor, deleting all available higher resolutions.

Thanks for your help Haldi.
I have used the program CRU, and he established the correct monitor resolution 812 x 456 but when I use eyfiniti this change to 1920x1080 and the picture is again small due to the small pixels. If I use windows 7 desktop assembly in the control panel it is all right, the resolution remains at 812x456 monitor, but I do not have the tool to correct the bezel. So, playing in full screen is not possible, just in windowed mode without bezel correction. I want to use full screen mode because the picture is better. how to lock the monitor resolution to 812x456 to remain in eyfinity group.

thanks

Hey slojani, did you try using SoftTH ?

Hay ,

IL-2 Clifs of Dover does not work with Softth because it uses DX10.

Thanks for help..