Widescreen Gaming Forum

hey guys . i just got my new pc . that is running on i7 3820k with 16gb ram & crossfire 7970 3gb .. when i plug my 3 24inch asus led monitors in . it works fine but when i bring up the catalyst control center to turn it into eyefinity for 3 screens to act as 1 it blacks out 1 of the monitors an only brings the 2 screens to gether an not the 3rd?!!

iv beeen payin around with it for th epassed 4 hours an cannot seem to find why this is happening :( please help!

http://i47.tinypic.com/1zl9lhi.jpg

theres a screenshot of what happends . if u see on the left it highlights the 2 screens but blakc out 1 of them :S

also i cannot duplicate all 3 screens only allows me to duplicate 2 of them :(

xD if you have Screen A B and C, and you Duplicate Screen A to B and C... it is twice right ?

So all 3 Work fine in Extended mode ? Then it's just a settings failure!

Sometimes its complicated to setup Eyefinity :)

Try out this:
Setup Extended mode.
Set Eyefinity Mode.
Try to change Resolution to 5760x1080.
Deactivate Eyefinit
activate Eyefinity.
Set eyefinity again.
if not working:
Deactivate Eyefinity.
Deactivate 2 side Monitors.
Set Eyefinity.
Try change resolution.

It's luck based ^^