Widescreen Gaming Forum

Hi all!

Today i've just upgrade my old 5:4 3x19" to 16:10 3x22". The exact model is Benq G2200W, wich is in the list of "compatible 57hz monitors".
I've upgraded yet muy TH2GO with the latest firmare, so i can now select 5040x1050 resolution. But... something is going wrong, it seems like real resolution is bigger than that, because i can move mouse out of screen in right and bottom directions. What is happening?

In Powerdesk resolutions list i have 2 1680x1050, one 60hz and one 57hx, but i try to manually select 5040x1050 57hz resolution and it doesnt work. How can i set correct 57Hz resolution?

I'm on a ATI 4870x2 with Catalyst 9.6. Best regards,
Gabriel

Problem solved, i explaine my setup, i think it could help some of you.

I have an ATI 4870X2 card, one DVI output is conected to a 24" Benq i use to work. The second DVI is connected to TH2GO, wich has attached 3x22" Benq G2200W.

Now i finally solved the problem and have both monitors running, the 24" at 1900x1200 and de TH2GO at 5040x1050 59Hz. After many Catalyst version test, what i did finally to work is:

- Upgrade TH2GO with the latest firware (THV2_v2.3.50.t6.61.pkg)
- Install Catalyst 10.2 (the orginal one from ATI site)
- Install latest Powerdesk (2.07)

After restarting system, i have to create 2 differents profiles in Catalyst control center and assign a key shorcut for each:
- CTRL+SHIFT+F11 activate 24" and set resolution to 1900x1200 at 60hz
- CTRL+SHIFT+F12 activate TH2GO and set resolution to 5040x1050 at 59hz

Because different refresh rates, sometimes i need to press key combination two times, because the first time i press Catalys sets incorrect resolution.

Hope it helps :cheers :cheers
Regards from Spain and sorry for my english
Gabriel