Widescreen Gaming Forum

The built in horizontal adjustment only corrects this error by approx 50 percent. I really do not know where to go from here. Final effort before returning to Amazon. Any help appreciated. Thanks.

The black border is down the left of each monitor. :doh

How does the monitor perform in other resolutions? As a single head? No border problem there?

John

have you upgraded the firmware?
do you have bezel management setup?
does it do this in every resolution?
how does it preform in single monitor mode?

have you upgraded the firmware?
do you have bezel management setup?
does it do this in every resolution?
how does it preform in single monitor mode?

All monitors are fine individually. Latest firmware. Drivers etc. This problem only occurs at 5040/1050. I have not tried bezel management though. Do you think that might work? Hmm interesting.

have you tried a lower Frequency, like 57hz. whats it running on right now?

I see by the pics, you have different monitors. One is a 2232bw, another is a 2032bw. That's probably your problem. Get three matching monitors that are known to work from the sticky thread here, and quit pullin your hair out trying to get these to work.

Are you gonna pay for them?

Did you end up checking Bezel Management?

Unless things have changed or my memory is wrong bezel management only effects the resolution you are in at the moment. For example if you are adjusting the bezel management for 5040x1050 you must be in that resolution. If you are in 4320x900 and adjust the bezel management and then switch to 5040x1050 you will still have a "problem". I point this out because I had a "blond" moment once under similar circumstances. Also I could be totally wrong.

Edit: Actually I just reread your post and noticed you said that the strip was on the left of each monitor. That would say to me it has nothing to do with bezel management, sorry.

I have returned to amazon for a refund. Titled, does not work on my system. I have just ordered the Optoma HD200X to cheer my self up.