Widescreen Gaming Forum

Hi all, I don't mind removing the bezels and fabricating a new case for my 3x24" monitors but wondering if anyone has any examples around?

I ask because I am not sure of the feasibility of aster taking the plastic case off, removing the thin sheet metal bezel that is usually on the side of the panel, keeping it all together.

I am just thinking about what I can do with that part. I did think remove it from the sides but obviously there will just be part of the screen with no active pixels so even if you butt them up to each other you would still have inactive areas of the screen. I think?


Anyone who has done it to get the minimum bezels got some pics?

Thanks.

It was talked about in this thread http://www.widescreengamingforum.com/forum/viewtopic.php?t=8518

Pics in the thread are dead. Here is the users site about the mod - http://www.mikevanelst.com/monitorproject/

Thanks guys, I didnt even realise anyone replied!

I looked at his pictures and I don't think it's worth the effort. I was really hoping that there would be a lot less bezel and I assume he did his best to get the minimum bezel width. As I currently overlap the monitors and am happy with that I am probably not that far off from where I would be without the case anyway.

Thanks.