Widescreen Gaming Forum

I cannot find a definitive answer on the Matrox site - sorry if this is obvious.

I have a homebuilt PC - GX280 and Vista 32bit
3 - 22in 2243WB Samsung LCDs

I have one Dual link DVI cable from the PC to the TH2GO (Or do I just use the cable that came with the TH2G from the PC to the unit?)- then three single link DVI cables to the LCDs and after updating the TH2G firmware I am not seeing the resolutions. I am wondering if I need 4 Dual link DVI cables.

Brad

No. From the unit to the monitors can be single link.

I and others have had trouble getting our cards to output over 2400*600 over DVI. I have a 9800GX2 and have been unable to get it to work, I don't really care because I just use a VGA adapter and pump 3840*1024 over VGA. But I doubt that that is an option for you because your using higher wide screen resolutions. I'm off to do a search for posts about my problem, I will report back if I find anything helpful.