Widescreen Gaming Forum

The HD Triple Stand XL description says "It isn't designed for 1+3 or 5x1 configurations", but the technical specs have "5x1-P Width" as one of the columns. Could someone clarify whether the XL supports portrait mode? I'm looking at using 24" displays.

KayDat wrote:The HD Triple Stand XL description says "It isn't designed for 1+3 or 5x1 configurations", but the technical specs have "5x1-P Width" as one of the columns. Could someone clarify whether the XL supports portrait mode? I'm looking at using 24" displays.

The HD Triple XL only comes with three pivots, so there isn't enough hardware for a 5x1-P. I've got a couple of extra pivots you could purchase, if you wanted to do 5x1-P with the HD Triple XL and only have a short pole. It will do 3x1-P with the included hardware.

How much are the pivots each? Looking in to freight forwarders atm to try and defray some of the costs since I'm from Aus. I might end up buying a triple monitor stand for $169 locally for my middle three monitors, and use my current desk mounted stands for my side monitors. Heck of a lot cheaper, but no where near as smooth.

I happen to have two extra pivots I could add for $25. That would put you $25 less than the WSGF Edition.

I have been looking for a triple monitor stand that can fit 3 27" Crossover 2720MDP GOLD LED PIVOT monitors. Would either of these stands be sufficient enough to support them? I'd like some reassurance before I commit.

Would like to buy the Heavy Duty Quad stand through WSGF so I can put 3 (3xu2311h) over 1(u2913wm). As far as I can see this would fit, do you guys agree? Also would like to know how long it will take to ship it to the Netherlands?

Happy buyer here, I ordered a Triple XL from France. Package posted 12/15, received 12/28. Had to pay an extra 67€ VAT/customs tax upon delivery.

I had been using an Aavara VS743 for a year. Excellent value, but ultimately it's a mistake for an avid multi-mon gamer not to buy the best stand possible right away. Just like you buy monitors that will last through multiple GPU upgrades, a stand should last through monitor upgrades.

The Triple XL is not only bigger, it's better in every way.
The base is HUGE and super stable: no need for a third hand to secure the stand when you're mounting that third monitor. Maybe it's a bit slippery though, so that the entire stand tends to move on the desk when you manipulate the screens or branches. Adhesive rubber pads would have been nice.
The five-segment bar is a godsend. Just make sure to tighten the screws before mounting it on the pole, they're very loose out of the box and you want the branches to stay in position as you attach and adjust the screens.
16:9 24" is a bitch, even moreso with the Acer GD245HQ's massive bezels, so three of these hardly fitted side-by-side on the Aavara stand. Had to make the center screen overlap the other two to "fold" my triple-display into a natural angle. It's all over now and I can finally enjoy bezel-compensated games on a continuous display surface.
For some reason my right panel was also noticeably lower than the other two on the Aavara stand, and the Triple XL's clever height adjustment system fixed that too !

Thank you Messrs. Ergotech & Clarke

I have a question regarding this stand.

Can I use it a dual stand? I want to use a Dell U3011 in landscape mode and a Dell 2007FP in portrait mode, is this possible?

In the future I might add another 2007FP, but for now dual.

Thanks in advance!

Negatruong wrote:I have been looking for a triple monitor stand that can fit 3 27" Crossover 2720MDP GOLD LED PIVOT monitors. Would either of these stands be sufficient enough to support them? I'd like some reassurance before I commit.

The stand was designed to fit 27" monitors. I've not heard of that brand. Look at the physical height and width specs, and then compare to the info on the product page.

Wijkert wrote:Would like to buy the Heavy Duty Quad stand through WSGF so I can put 3 (3xu2311h) over 1(u2913wm). As far as I can see this would fit, do you guys agree? Also would like to know how long it will take to ship it to the Netherlands?

Yes, that should work. Double check the specs to make sure. I've got 3x U2211H over a U2913WM. I ship US Global Priority. Estimate is 6-10 days, outside of customs clearance.

Xfinity wrote:I have a question regarding this stand. Can I use it a dual stand? I want to use a Dell U3011 in landscape mode and a Dell 2007FP in portrait mode, is this possible? In the future I might add another 2007FP, but for now dual.

Thanks in advance!

Yes, that should work fine. The stand will be stable with two montors.

Xfinity wrote:I have a question regarding this stand. Can I use it a dual stand? I want to use a Dell U3011 in landscape mode and a Dell 2007FP in portrait mode, is this possible? In the future I might add another 2007FP, but for now dual.

Thanks in advance!

Yes, that should work fine. The stand will be stable with two montors.[/quote]

Thanks the reply and me not having anymore headache with all information I have about different monitor stands. You will soon get a order from me .

Hi,

I have 3 x 37" Achieva QH-270 IPSB monitors that I would like to mount in 3 x 1 (L).

I have a suspicion that these monitors are too large though for the WGSF triple monitor stand, would I be correct in thinking that?

If so, can anyone suggest an alternative?

Thanks

Simple_One wrote:Hi,

I have 3 x 37" Achieva QH-270 IPSB monitors that I would like to mount in 3 x 1 (L).

I have a suspicion that these monitors are too large though for the WGSF triple monitor stand, would I be correct in thinking that?

If so, can anyone suggest an alternative?

Thanks

Little typo there. These are actually 3x 27" monitors. I can't find any tech specs on your monitor, but you should be able to figure this out quickly. Grab a tape measure and determine the physical width of the monitor. No the diagonal of the screen, but the full left-right width including the bezels.

The WSGF and HD Triple XL Stands are designed to hold monitors 25.5" wide. If you're below that, then you're golden. Some folks have done with even a touch wider (Dell 30" panel), but you won't get as much angle between the monitors.

It would be great to see some galleries of the stand in use from users along with screen models, so one can physically see how things fits.

Anyone with a stand, get snapping some shots and upload them to our gallery here.. http://www.wsgf.org/node/add/ng-wizard/ ... lery_image

Yep, 27" sorry bout that.

I measured them up at 660mm (w) x 410mm (h), each weighing about 9kgs.
So that's 25.98" (w) x 16.14" (h) and about 19.8 lb's.

Looks like I'm out of luck with the WSGF then

Hello WSGF,

After almost a week of research, I'm very happy to have found & decided to go with the HD Triple XL Stand for my 3 ASUS VE278Q's

skipclarke wrote: According to the HD Triple XL product page, it will handle monitors 25.5" wide. Checking the specifications page of your monitors

We find that the VG278H and VE278Q are both 25.31" wide (643mm). Assuming that ASUS provides the right specs for their monitors, they will fit.

So many stands I've looked into have been somewhat restrictive or completely incompatible in the 25" + category. Thank you for designing this product for people with this specific need. Anyways, I got a great deal on these monitors and I've only had them for a week now so I absolutely can't wait to get this awesome setup going.


Thanks!

EDIT : I'll be updating with setup pics as soon as package is received.. The anticipation is almost as bad as waiting for delivery of my gpu & monitors..

skipclarke wrote:

Simple_One wrote:Hi,

I have 3 x 37" Achieva QH-270 IPSB monitors that I would like to mount in 3 x 1 (L).

I have a suspicion that these monitors are too large though for the WGSF triple monitor stand, would I be correct in thinking that?

If so, can anyone suggest an alternative?

Thanks

Little typo there. These are actually 3x 27" monitors. I can't find any tech specs on your monitor, but you should be able to figure this out quickly. Grab a tape measure and determine the physical width of the monitor. No the diagonal of the screen, but the full left-right width including the bezels.

The WSGF and HD Triple XL Stands are designed to hold monitors 25.5" wide. If you're below that, then you're golden. Some folks have done with even a touch wider (Dell 30" panel), but you won't get as much angle between the monitors.

Think I could put my 3x30"rs on WGSF triple monitor stand? It would be nice to get away from ever using monoprice stands when I want to add a monitor on top.

This user purchased a WSGF Edition for 3x 30" panels. I offered to refund his purchase if the stand didn't work. I never got a refund request, so I'm assuming it worked.

http://www.wsgf.org/forums/viewtopic.ph ... 92#p138492

Just checking if WSGF is still active in shipping the Ergotech stands? I am looking for the Heavy Duty Quad. Also curious about how much time it will cost to get the item.
Living in Holland. Going for a setup with 3x Asus VG248QE https://www.asus.com/Monitors_Projector ... s/VG248QE/
and 1x Dell U2412M http://accessories.us.dell.com/sna/prod ... u=320-2676

Dforce wrote:Just checking if WSGF is still active in shipping the Ergotech stands? I am looking for the Heavy Duty Quad. Also curious about how much time it will cost to get the item.
Living in Holland. Going for a setup with 3x Asus VG248QE https://www.asus.com/Monitors_Projector ... s/VG248QE/
and 1x Dell U2412M http://accessories.us.dell.com/sna/prod ... u=320-2676

Yes, we are still shipping. The HD Quad comes direct from Ergotech. I don't stock that product. I only stock the WSGF Edition and HD Triple XL. Unit will ship US Postal Global Priority. Lead time on anything shipping from Ergotech is about a week.

skipclarke wrote:

Dforce wrote:Just checking if WSGF is still active in shipping the Ergotech stands? I am looking for the Heavy Duty Quad. Also curious about how much time it will cost to get the item.
Living in Holland. Going for a setup with 3x Asus VG248QE https://www.asus.com/Monitors_Projector ... s/VG248QE/
and 1x Dell U2412M http://accessories.us.dell.com/sna/prod ... u=320-2676

Yes, we are still shipping. The HD Quad comes direct from Ergotech. I don't stock that product. I only stock the WSGF Edition and HD Triple XL. Unit will ship US Postal Global Priority. Lead time on anything shipping from Ergotech is about a week.

Ah thats good news. Is it possible to get the extra telescoping wings with the HD Quad?