Problem with New Wide Modes on ATI Cards - Official Thread

[fizzer]

Well... Tried the 4th monitor method and 10.3 as posted above...

No joy for 3840 x 1024 on ANALOGUE TH2GO... :(

Gonna try 10.2 but don't hold much hope. ATI are just not going to support it I think.

EDIT: 10.2 does not suport 3840 x 1024.... Tried every which way and lost...

Roll on new Nvidia so I can buy a cheaper GTX 295 and never see the like of ATI again :lol:

[ScoobyZ]

I can confirm 5040 x 1050 with Catalyst 10.2 .

I have a 4870X2. In case it helps..

I did a fresh installation using a 4th monitor. After I installed all necessary drivers, I installed PowerDesk.

Then I connected the USB cable to my TH2GO (DVI Edition) and then the 3 monitors.

After that and following the setup, I did see the 1680x1050 (independent mode).

The pc rebooted and then I had 5040 x 1050 on my 3 x 22'. I am rock steady for the past 3 days now and never had issue. Lets hope it s

I have been trying all afternoon just can't get my ATI 5850 @ 5040x1050 on triplehead2go :(

Any help appreciated.