Widescreen Gaming Forum

Ok I solved part of the problem : it seems that under Windows 10, pluging a monitor into my upper graphic card was causing these flickering (but everything is fine under Win 7 so this is still a mystery).
I had to plug all my 3 monitors to my second - lower- graphic card with :

1xHDMI
1xDVI-D
1xDVI-D into a DVI-I port

Bam, flickering problem gone.

But now there is another problem ONLY in games, when playing surround and fullscreen : very often I get a kind of screen tearing / kinda vertical sync problem.
It appears sometimes in the middle of the screen, and most of the time in the bottom of it. I tried turning on and off the Vsync in game or in the nvidia control panel, nothing changes.

Help anyone? Thanks.

Too bad it didnt help, i had exactly the same problem. Dying light, witcher etc flickering, wolfenstein no problem. I had some tearing issues with the turbo mode of tune up utilities but i dont know if you are using that. Maybe a clean(remove all profiles) 355.82 install with one monitor connected on the top card then restart connect the other two and activate sli ? Maybe try the other sli connector on the cards.

No I don't use Tune up.
I'll try to use DDU again to do a clean uninstal of my graphic drivers and instal them again following your advice. It is strange because when I have my wave / vsync problem, the game and the driver crash after a few minutes and I have to reboot the PC. (I think I get kernel errors or something)

Just to be sure, connecting three monitors to one card when in SLI and enabling Surround can't cause this strange kind of vsync problem in games right?

Still I am disappointed and plan to stay on Win7 for a while, everything is very stable on it. But one day I'll be forced to stay on windows 10 for the games using DirectX 12...

I havent tried 3 monitors on 1 card yet, but i imagine its not the best setup for sli.
This windows 10 update causes a lot of problems, i have to use software acceleration in edge or it wont work, my taskbar is all over the place, windows menu is on the left monitor, i get a fuzzy resolution on all kinds of programs and have to tick the compatibility high res box on a lot of them. Hopefully they will update this in the near future.

Yeah I think Windows 10 is not the best solution right now, especially with settings such as ours (SLI + Surround). I tried playing on one screen, and everything was fine so Nvidia Surround is causing all these problems.
Well Win10 is free for a year, maybe I should try a bit later when they update the OS.

I am running all 4 monitors off one gpu on 970 gtx sli with 3x2560x1440 landscaped at 7680x1440 and my extra 1920x1200 in portrait I am using Gigabyte G1 gpu's.

One note is that I was using the 3 dp ports and one dvi and I was getting some screen blinking etc. I saw the review here on the Accell dp 1.2 cables and ordered them but they did not work any better. So what I did is use the 2 dual dvi, one dp and the hdmi for my secondary screen. Everything is working much MUCH better. Again everything is plugged into one GPU. I have read in multiple places that using the one GPU is better than plugging using both gpu's to plug the monitors into. If I find where I saw this I will come back and link it.

sounds like a problem with the sli bridge put it on and off again or just flip up and down abit helps sometimes. happens really often.