Widescreen Gaming Forum :: View topic - First time Triplhead2go Digital today. Some Questions.

It's working now, followed your writeup to the letter.

1) Clean install of Win 7 x64
2) Updated Firmware (from same version to same version, I believe this resets the GXM settings?)
3) Reboot
4) Installed Nvidia 195.81 BETA drivers
5) Reboot
6) Installed Matrox PowerDesk 2.06
7) Reboot
8) Ran through Wizard, set 1680x1050 via the Auto selection.
9) Reboot
10) Wizard runs through the remaining three checkpoints BUT the screens change and black out. OCD for the monitors shows it running at 12x something resolution.
11) Shutdown
12) Startup, resolution is 1680x1050.
13) Swap displays, so I could get output on center monitor.
14) Via Nvidia Control Panel configured custom resolution as per OP instructions, with a Vrefresh of 59.400
15) Edited ini file as per OP instructions.
16) Rebooted
17) Matrox prompt detected changes, click yes for reboot.
18) Reboot
19) Change desktop resolution via Windows to 5040x1050.
20) Subsequent reboots, all is well in wonderland.

Author:	juxreal [ 29 Jan 2010, 07:46 ]
Post subject:	First time Triplhead2go Digital today. Some Questions.
Good morning from Germany. Today, my Triplehead2go Digital should be arrive. I have a short question about installation. - Is this Fix need 100%? My System: Windows 7 64 Bit , 2Samsung 223 BW 22" 1 zalman 3d 22" all three 16801050 - Some easy tricks to add interlace mode for 3D function from the Zalman 3D Monitor? Changing the Firma ware ( matrox triplehead3go from this site ) is not possible for me ( noob ) Thx a lot. Code:* It's working now, followed your writeup to the letter. 1) Clean install of Win 7 x64 2) Updated Firmware (from same version to same version, I believe this resets the GXM settings?) 3) Reboot 4) Installed Nvidia 195.81 BETA drivers 5) Reboot 6) Installed Matrox PowerDesk 2.06 7) Reboot 8) Ran through Wizard, set 1680x1050 via the Auto selection. 9) Reboot 10) Wizard runs through the remaining three checkpoints BUT the screens change and black out. OCD for the monitors shows it running at 12x something resolution. 11) Shutdown 12) Startup, resolution is 1680x1050. 13) Swap displays, so I could get output on center monitor. 14) Via Nvidia Control Panel configured custom resolution as per OP instructions, with a Vrefresh of 59.400 15) Edited ini file as per OP instructions. 16) Rebooted 17) Matrox prompt detected changes, click yes for reboot. 18) Reboot 19) Change desktop resolution via Windows to 5040x1050. 20) Subsequent reboots, all is well in wonderland.

Widescreen Gaming Forum https://www.wsgf.org/phpBB3/

First time Triplhead2go Digital today. Some Questions. https://www.wsgf.org/phpBB3/viewtopic.php?f=67&t=19051	Page 1 of 1

Page 1 of 1	All times are UTC [ DST ]
Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/