Widescreen Gaming Forum
https://www.wsgf.org/phpBB3/

Eyefinity 6 Physical Configuration
https://www.wsgf.org/phpBB3/viewtopic.php?f=66&t=25259		 Page 1 of 1
Author:  fbass [ 10 Jan 2013, 22:29 ]
Post subject:  Eyefinity 6 Physical Configuration
I have my Eyefinity 6 setup in a 3x2 matrix, native resolution. Desktop is visible on all monitors. I'm running FSX on the monitors. Question: Current physical configuration -I have 5 of the monitors in a straight line with an additional monitor just below the middle monitor in the row. My purpose was to display the scenery outside the cockpit while displaying the instruments in the lower monitor (undocked window dragged to this lower monitor. NOTE: All the monitors are Asus 27" digital monitors connected to graphics card using display port connectivity.

Does anyone have a solution for this requirement?

Thanks so much.

Frank
Author:  Delphium [ 11 Jan 2013, 11:28 ]
Post subject:  Re: Eyefinity 6 Physical Configuration
Having talked to a friend on the phone yesterday whom is setting up a similar system for a spitfire, I understand that it is possible to write a script for FSX to align all the windows where you need them, however my friend said he had to do some revising to work it out again.

So I know it would be possible just not sure how.
I believe the guys over at SimHQ Forums would likely know.
Author:  skipclarke [ 11 Jan 2013, 19:08 ]
Post subject:  Re: Eyefinity 6 Physical Configuration
You may have better luck with this if you did a 5x1-Landscape Eyefinity, and then had the additional monitor as an extended display. That would give you two "monitor surfaces" to use - the 5x1-L SLS and the Extended monitor. You could then arrange them one over the other in the CCC or Windows display properties. You might even be able to natively configure this in FSX with it's dual monitor support.
Author:  Haldi [ 12 Jan 2013, 18:51 ]
Post subject:  Re: Eyefinity 6 Physical Configuration
Quote:
Does anyone have a solution for this requirement?


Physical configuration ? You mean a Monitor stand? or Graphicscard that can handle 6 Monitors ?
Author:  AllGamer [ 14 Jan 2013, 16:22 ]
Post subject:  Re: Eyefinity 6 Physical Configuration
ok, native will look like this 3x2
my old rig
Image

for your Flight Sim setup, or StarCitizen setup for that matter
You want a 5:1 configuration
so you have 5 monitor Desktop 1
and 1 monitor on Desktop 2

in the Catalyst Control Panel Eyefinity Setup Wizard, select the 5:1 option, and leave 1 monitor out

Troubleshooting steps:
if you get trouble with it not letting you only select 5 monitor, and forces to take all 6
then unplug 1 monitor, the one that is going to be the Desktop 2 monitor

then after you complete the 5:1 monitor setup, plug back the 6th monitor for Desktop 2

another easy alternative is to plug the 6th monitor for Desktop 2 on the 2nd Video card, assuming you are using Crossfire or Trifire setup, or perhaps even Quadfire setup :rockout:

fbass wrote:
I have my Eyefinity 6 setup in a 3x2 matrix, native resolution. Desktop is visible on all monitors. I'm running FSX on the monitors. Question: Current physical configuration -I have 5 of the monitors in a straight line with an additional monitor just below the middle monitor in the row. My purpose was to display the scenery outside the cockpit while displaying the instruments in the lower monitor (undocked window dragged to this lower monitor. NOTE: All the monitors are Asus 27" digital monitors connected to graphics card using display port connectivity.

Does anyone have a solution for this requirement?

Thanks so much.

Frank
Author:  vtristram [ 05 May 2013, 09:33 ]
Post subject:  Re: Eyefinity 6 Physical Configuration
:welcome Hi AllGamer,
Very impressive rig you have there! I can judge that because I have a 3:1 set.
The crux with all the setups that span the desktop over n monitors is that all monitors have to,be connected to the same graphics card. Concur?

My question: what are your framerates like with FSX?
I hear of phantastic fps from many gamers but they are all running a one-monitor setup! That's no problem. As soon as you span the desktop over 2 and more LCSs the fps seem to go down to around single digit values. Do you experience that, too? If not, I should very much like to see how you did it!
Tx!
Volker
I5-2500K, 2XRadeon 5970, 16GB RAM, SSDs for Os and FSX.
Fps at Andras Field: 5-7
Page 1 of 1 All times are UTC [ DST ]
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/