Widescreen Gaming Forum

do you have an AMD Card lying around, or a friend which could lend you his card for a day and test what happens?

I don't to both.

I did figure out the 165 hz problem. There is an option in the OSD menu of the pg279q for "overclocking". That needs to be enabled for 165hz.

It appears that the ...

My bad, it's not in the OSD: m
Just press the "GamePlus hotkey" and use the d-pad to enable the fps counter.

Update:

I've discovered something new after using DDU, but not because of using DDU.

I have 2 PG279Qs with one PG278Q in 1x3 Surround with a max refresh rate of 120hz when these tearing ...

RotecLaser wrote:take a look at OSD settings.

Anything in particular to look at?

One thing I noticed with the OSD settings is that the option to choose FPS is gone. Normally, the Swift allows you to choose between FPS speed when not in Nv Surround.

SLI, you say... Are you using a HB bridge ?

I sure am! The MSI one.

I also noticed that 120hz seems to work properly when SLI is disabled. So it may be that this is all caused by SLI...

'120 Hz' is just the display mode. What I meant to say is: in your OSD menu, navigate to OSD settings, there ...

Check OSD settings, there must be a way to display the actual refresh rate. What GPU are you using ?

Hi Scavvenjahh! OSD states 120 hz. I feel rather confident that it's not accurate though. I can't think of another reason why G-Sync would tear when over ~95 FPS but be smooth under it.

I am ...

Hello all!

I have a strange problem where the actual FPS of my surround is lower than the settings in NV Control Panel.

First, when I enable surround with my 2 PG279Q and 1 PG278Q I don't get the 144FPS option, only 120. I can do 144FPS on each monitor when not in Surround. I don't mind losing the ...