Widescreen Gaming Forum

Fixed my problem. Noticed the plate for the tube clamp was off by a couple of mm which was throwing the whole arm off, fixed that than after some tweaking I got it setup good enough.

20170302_101858.jpg

It is hard getting it perfect because of the middle monitor being different but I think I ...

Finally got my stand installed yesterday, loving it well worth the money.

I did notice though the left monitor doesn't seem to be straight, it's angled down to the the left more, I did try to get the arm as straight as I could but when I tightened the clamp it was raising it slightly to the right ...

Got my stand last week, finally got around to pulling it out and mocking everything up... this is one big mother especially with 3x 27" screens.

Cant wait to have this thing fully setup in the coming months .

I did notice one small problem, the locking pin for the monitor bracket head thing isn't ...

c1em3ntchua wrote:You won't have any issues with the angle. I am using 3 x 27" at 45 degrees.

Cool , now to start saving for this monster .

Been looking at this thing for a little while and just wondering, with 3x 27" what angles can the side ones come into?

I'm a little tight on room and figure I'll need them around 30 - 45°.

With the Thru Desk Mount could a pine desk handle it with 3 27" or could that eventually cause the desk to ...