Widescreen Gaming Forum

I can confirm the ds100 can hold a 30" monitor (HP LP3065) in portrait, just barely. However, for the center monitor to fit above the base, you need to edge the arm about half way above the 14.5 inch pull, so the clamp hangs a little over. I was a little hesitant to do this at first, but even with ...

Thanks for the response scooby

My HP LP3065s measure:

3x 27.2W x 9.5 x 23.2H inches

= 81.6W

If all three 30"s don't fit, I have the option of surrounding one 30" with two 28" monitors which would shave off about 2 inches. In this case, dimensions would be as follows:

1x 27 ...

@NZCoyote, your on the money on that my friend. The clamps holding the monitors can be adjusted to move left/right and swivel but not up or down. To adjust the the level of the two outside LCDs I added a 1/16" thick washer on the bottom section between the clamp and the extension arm. I'll try to ...