Widescreen Gaming Forum

http://widescreengamingforum.com/forum/forums/multi-monitor-gaming/amd-eyefinity-discussions/14279/eyefinity-5x1-p-live-cayman-driver


I used the uninstall from 11.11 installed 10.12 and then installed 10.12a hotfix on top of the 10.12. Some suggest using a driver sweeper.
It works a lot ...

I wasn't having crossfire problems until I installed 11.11, not only did I have crossfire problems but frame rate dropped about 25%.
Went back to 10.12 plus 10.12a hotfix problem solved. This was tested with Iracing, AcesHigh and FSX.

[email protected]
W7 64bit
ATI 5870 E6
ATI 5870
5x1 Profile ...

Aces High, free down load and two week trial, steep learning curve. A10 Warthog, very steep learning curve. Iracing.

With the 11.1 drivers out should I install the hotfix over those or use the older 10.12 drivers?

Thanks,
Danny

I'm currently running an original 5870 with three 24" 1200x1900 monitors, one dell with display port and two with DVI. I want to run 5x1 profile.
So I ordered the Saphire 5870 eyefinity 6 off NewEgg, purchased 4 active display port adapters and two 24" DVI monitors. So I'll have four monitors ...

Not sure if it was just me, but I fresh installed 11.1 and it didn't recognize 5x1P with my 5 Samsung 245BW. I uninstalled 11.1, then proceeded to install 10.12a which DID allow 5x1P. I think just installed 11.1 over 10.12a and now 11.1 sees 5x1? Odd...


Are you using display port adaptors ...

Lockon A10 demo with three 24" screens in portrait mode, using an ATI 5870. Check it out full screen in HD.

http://www.youtube.com/watch?v=rduAoViiarw